Xh-m608 Manual ((top)) Site

To program the board, long-press for 3 seconds to enter the internal menu: Description P0 Working Mode

Storage batteries, lithium batteries, and solar systems. Physical Dimensions: 81mm x 54mm x 18mm 2. Terminal Wiring Configuration

As with any electronic component, proper handling, correct wiring, and appropriate current ratings will ensure years of reliable service. The XH-M608 offers an excellent balance of functionality and simplicity, making battery management accessible to professionals and hobbyists alike.

Below is a comprehensive article/manual regarding the XH-M608, assuming its most common application as a DC Motor PWM Speed Controller.

The Xh-m608 interface is designed to be intuitive and user-friendly. Here are some key elements to familiarize yourself with: Xh-m608 Manual

You can view the currently set lower limit by short-pressing ADD and the upper limit by short-pressing DEC from the main display.

Press quickly to select a parameter, adjust its value using + and - , and press SET again to save. Parameter Reference Table Description P1 Charging Mode Selects the battery charging routine. P2 Discharging Mode Selects the battery discharging routine. U-1 (in P1) Lower Limit (Start Charge) Relay closes when voltage drops to this value. U-2 (in P1) Upper Limit (Stop Charge) Relay opens when voltage rises to this value. U-3 (in P2) Lower Limit (Stop Discharge) Relay opens when voltage drops to this value. U-4 (in P2) Upper Limit (Start Discharge) Relay closes when voltage rises to this value. P3 Voltage Calibration Calibrates the displayed voltage against a multimeter ( P4 Delay Start Timer Sets a delay timer ( minutes) before the relay toggles. Common Setup Examples Example 1: Setting up a 12V Lead-Acid Charging System (P1)

This document is an independent technical reference for the XH-M608 module. Specifications and features are based on manufacturer documentation and field testing. Always refer to the included instruction sheet with your specific module, as minor variations may exist between batches and suppliers.

Press to enter the menu or confirm settings. Middle Button (+): Increases value / Navigates up. Right Button (-): Decreases value / Navigates down. 3. Essential Settings To program the board, long-press for 3 seconds

If the voltage reading seems off, many users cross-reference with a standalone multimeter to verify the ±0.1V accuracy. AliExpress wiring diagram or a step-by-step walkthrough for setting the overvoltage protection Voltage Protection Board XH-M608 - Make Electronics

The is a versatile, programmable, digital battery charge and discharge controller module . Operating across a wide DC 6–40V input range , this module functions as an automated supervisor to prevent dangerous overcharging and over-discharging in lead-acid, lithium, and AGM batteries. It achieves this by using an onboard microcontroller to actively sample real-time voltage and toggling an isolated 10A SPDT relay to connect or disconnect a battery charger or an external load. Technical Specifications

To automate a charger, route one wire of the charger’s output through the and NO terminals. The relay will close and complete the circuit only when the battery needs charging. ⚙️ Programming and Settings

The relay stays closed to power your load until the battery hits the undervoltage limit. 3. Programming & Modes The XH-M608 offers an excellent balance of functionality

operates in two distinct functional modes depending on your application needs: 1. Charging Control Mode (P1)

Connect your (appliance, inverter, light) to the OUT+ terminal. Connect your Load Negative (-) to the OUT- terminal. Troubleshooting Common Issues The display reads "ERR"

Increase the difference between the lower (U₁) and upper (U₂) voltage settings to prevent "chattering" (rapid on/off cycles). 6. Important Safety Warnings