Zkteco Ua300 Factory Reset __hot__ -

Use this method if you have full administrator access to the device menu and want a clean slate. Step 1: Access the Advanced Settings Press the button to open the main menu.

If you're still experiencing problems or have forgotten the admin password, contact ZKTECO support or an authorized service center for further assistance. They can provide additional guidance or repair/replace the device if needed.

: A full factory reset deletes all user accounts, fingerprint templates, RFID card data, and punch logs stored locally on the device.

: Note the exact time shown on the device's home screen (e.g., 14:20). Generate a Super Password Subtract the current screen time from Square the result ( The resulting number is your Super Password for that specific minute. Enter Service Mode . When prompted for an ID, enter and enter your generated Super Password. Clear Admin : Once in the menu, go to and select Clear Admin Privileges zkteco ua300 factory reset

Press the tamper switch quickly within 30 seconds of the beep to reset the admin password to the default (typically 1234 or 12345 ). Default/Common Setting Default IP 192.168.1.201 Default Admin ID 8888 Default Password 1234 or 12345

Press Menu on the device. When it asks for the admin user, type 8888 and press OK/Enter .

Press the key on the UA300 keypad to enter the main menu. Use this method if you have full administrator

Locate and click the or Clear All Data button to wipe transactional history. Step 3: Initialize the System

Open , ZKTime 5.0 , or the Biotime software on your computer. Navigate to the Device or Terminal Management tab. Ensure the status icon for the UA300 shows as Connected .

Use the arrow keys to navigate to (represented by a gear icon) and press M/OK . They can provide additional guidance or repair/replace the

Locate and select the (or Reset Settings ) option.

: Press the Tamper Switch three times rapidly within 30 seconds. A long beep confirms the admin password has been reset to the default ( 12345 ). 3. Software Reset (Using ZKTime)

Go to > Restore Data to reload your employee fingerprint templates and user names back onto the terminal.

You need to delete all attendance logs and employee fingerprints/IDs before transferring ownership.