En Iso 17660-1 Pdf [updated] Jun 2026

. It applies to work performed both in specialized workshops and directly on-site. Load-Bearing vs. Non-Load-Bearing The standard is divided into two distinct parts: Part 1 (EN ISO 17660-1):

Covers joint preparation, preheating, and environmental conditions.

The Definitive Guide to EN ISO 17660-1: Welding of Reinforcing Steel

Check your local national organization (like AFNOR in France or AS/NZS in Australia/New Zealand) for localized versions. Why Use the Official Version? en iso 17660-1 pdf

) specified for the parent material. The failure should ideally occur outside the weld and the HAZ.

This standard is critically important because welding in construction is considered a "special process." The final quality of a weld cannot always be fully verified by testing the finished product alone, so the standard helps ensure quality is built into the process from the start.

The EN ISO 17660 series is split into two distinct parts based on the structural intent of the weld. EN ISO 17660-1 EN ISO 17660-2 Load-bearing joints Non-load-bearing joints Structural Role Transfers calculated design forces Used for positioning/tack welding Quality Control Highly stringent testing required Simplified quality requirements 6. Accessing the Document Non-Load-Bearing The standard is divided into two distinct

: Authorized commercial distributors of engineering standards. To help provide more specific information, tell me:

Not all rebar can be welded. The standard specifies which steel grades (e.g., B500B, B500C according to EN 10080) are permissible. Weld the wrong grade, and your joint becomes brittle.

Details template requirements for shop instructions. ) specified for the parent material

: Complete versions are available for purchase or viewing on platforms like Sky Bear Standards ISO 17660-1 - iTeh Standards

Two bars overlap side-by-side and are joined by longitudinal fillet welds. The overlap length must be calculated carefully based on the bar diameter to guarantee effective stress transfer. Strap Joints (Splice Plates)

EN ISO 17660-1:2006 - Welding of reinforcing steel - iTeh Standards