Qidi X-pro Manual | ORIGINAL |

and manual use helpful diagrams for tasks like tightening screws or installing the turbofan mouthpiece. Software Guidance: It includes basic instructions for

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. qidi x-pro manual

| Problem | Common Causes and Solutions | | :--- | :--- | | | - Unclean Bed : Clean the print surface with isopropyl alcohol. - Incorrect Nozzle Gap : Re-level the bed. - Incorrect Temperature : Ensure the bed and nozzle are at the correct temperature for your filament. | | Print Not Sticking | - Bed Leveling : Re-level the bed for a perfect first layer. - Glue Stick : Apply a fresh, even layer of glue stick to the bed. - Temperature : Double-check that your slicer settings are applying the correct temperatures. Some slicers default to PLA temperatures, so a manual preheat might be needed. | | Warping / Cracking | - Enclosure : The X-Pro has an enclosure; close its doors when printing ABS or Nylon to maintain a warm environment and prevent warping. - Cooling : Turn off the part-cooling fan for the first few layers when printing ABS. | | Failed Print on Power Outage | - Power Outage Detection : The X-Pro includes a power failure or "breakpoint" function. If the power cuts out, the printer will save the head position and resume printing from that point when power is restored. | | The Printer "Thinks" Home is Wrong | - Factory Reset : If the printer seems confused about its maximum print volume or home positions, perform a "Factory Reset" via the settings interface, then power off and on. This can resolve odd travel limits. | and manual use helpful diagrams for tasks like

Snip the shipping zip ties holding the X-axis and Y-axis gantry secure. Install the Dual Extruder: Lower the extruder assembly onto the carriage mount. Secure it using the provided screws from the accessory box. If you share with third parties, their policies apply

| Mode | Description | |------|-------------| | | One extruder only – standard printing. | | Duplicate | Both extruders print the same object simultaneously. Doubles output. | | Mirror | One extruder prints mirrored copy – ideal for symmetrical parts. | | Dual | Two materials/colors in one object. Requires Ooze Shield & Purge Tower. |

| Problem | Likely Cause | Solution | |---------|--------------|----------| | First layer won’t stick | Z too high / dirty bed | Re-level, clean with IPA | | Stringing (PLA/ABS) | Temp too high | Reduce nozzle temp by 5°C | | Layer shift | Belt loose | Tighten X/Y belts (hex key) | | Clogged nozzle | Heat creep / debris | Cold pull: heat to 100°C, pull filament | | Dual extruder collision | Wrong mode set | Check "Single/Dual" in slicer & LCD | | Filament jam in tube | Bent PTFE tube | Replace PTFE tube (2 mm ID, 4 mm OD) |

Print Not Sticking: Re-level the bed and ensure the bed is clean. Use glue stick or ABS slurry if necessary. Key Takeaways 300 × 250 × 300 mm. Nozzle Type: MK10. Features: Dual Extruder, Enclosed Cabinet, WiFi Printing.