features a rugged, weatherproof structure designed for commercial, residential, and industrial perimeter safety. Understanding these foundational features prevents hardware errors during installation:
Note: If the internal relay drives an electric lock directly, it is highly recommended to install a backward diode across the lock’s positive (+) and negative (-) terminals to suppress voltage spikes. Complete Programming Matrix Programming the Go to product viewer dialog for this item.
The is primarily a standalone access control keypad designed for single-door security. It allows authorized entry via RFID cards, numeric PINs, or a combination of both. Key Hardware & Technical Features
Whether you need to install the device, change an admin code, program new key fobs, or wire an electric lock, this ultimate guide compiles everything found in the official Obohands V2000-C User Manual . Technical Specifications Overview
| Parameter | V2000-C | V2000-C Pro | |--------------------|--------------------|---------------------| | Input channels | 1 (BNC) | 2 (BNC + SMA) | | Sampling rate | 10 Hz | 100 Hz | | Storage | 8 GB internal | 32 GB + SD slot | | Battery life | 8 hours | 12 hours | | IP rating | IP52 | IP54 | v2000-c user manual
: If you forget your master code, look for the "Hard Reset" jumper on the back of the circuit board to return to factory settings. Conclusion
Supports RFID card only , PIN only , or Card + PIN for enhanced security.
Configuration is handled directly via the keypad using a master management code (default is often ).
Type a [6-digit opening password] , and listen for the long confirmation beep. The is primarily a standalone access control keypad
If you have a specific brand, please check your device label — but these tips apply to 95% of V2000-C units.
separates into distinct operational zones. Use standard multi-strand alarm cable to make your connections: Wire Color Terminal Designation Connected Component / Function +12V DC (+9-12V) Main positive power input from dedicated supply unit Black Common ground return pin Green NC (Normally Closed) Fail-safe locking mechanisms (e.g., Magnetic Locks) White NO (Normally Open) Fail-secure locking mechanisms (e.g., Electric Drop-Bolts) Yellow COM (Common) Relay voltage distribution line Blue PUSH / OPEN Request-to-Exit (REX) momentary push button Purple BELL / BELL Output pair wired directly to a localized door chime Programming & Parameter Setup
The term "V2000-C" appears across a wide range of products. To find the right manual, first identify your product category. The search results reveal several possibilities:
Type the [4-Digit User Slot Number] (e.g., 0008 ) or swipe the card directly →right arrow Confirmation chirp sounds. Enter programming mode →right arrow Press [4] →right arrow Technical Specifications Overview | Parameter | V2000-C |
: Non-polarized output pins to route mechanical doorbells directly via front-panel button tracking. Master Keypad Programming and Administrative Controls 1. Entering Administrative Mode
: Connect to the "Normal Open" (NO) or "Normal Closed" (NC) terminals depending on your lock type (fail-secure vs. fail-safe). Exit Button
The system tracks users through a unique 4-digit User Number (ranging from 0001 to 1000 ). Enter programming mode. Press [0] (Orange LED activates). Type the [4-digit User Number] (e.g., 0025 ). Swipe the 125KHz EM card over the reader.