The absolute minimum footprint area for the foundation plate must measure .
The GTE 2500 features an automatic lubricating system that keeps the carriage and lifting nuts functioning smoothly.
The is a professional-grade, electromechanical two-post automotive lift specifically engineered for garages and tire shops. Characterized by its robust screw-drive mechanism and base-frame construction, it is designed for lifting passenger cars and light commercial vehicles with a gross weight of up to 2,500 kg . Technical Specifications
is a base-frame, electromechanical two-post lift designed for passenger cars and light commercial vehicles Doyle Technologies Inc Weight Capacity: Rated for a maximum load of (approx. 5500 lbs). Load Distribution: Permissible front-to-rear load ratio is 2:3 or 3:2 Lift Metrics: Boasts a maximum lifting travel of , bringing the total lift height up to depending on the pad setup. Drive Mechanism:
A built-in chain fracture switch provides an immediate halt in case of mechanical failure. Lubrication: hofmann duolift gte 2500 manual
The foundation must be level and capable of supporting the load (concrete strength requirements are mandatory).
Двухстоечный подъемник Hofmann Duolift GTE 2500
| Problem | Possible Cause(s) & Solution | | :--- | :--- | | | 1. Jammed screw mechanism: The lift screw may be jammed, often due to running out of travel. 2. Chain slip: The synchronization chain may be loose or slipping over its sprocket. 3. Debris: Foreign objects may be obstructing the screw. Solution: Manually operate the mechanism with a spanner from the top of the column to try and free it. Inspect the chain for tension and wear. | | Lift is slow or noisy | 1. Lack of lubrication: The self-lubricating system may be depleted or the screw dry. Solution: Apply a suitable high-pressure grease to the lifting screw threads. | | Uneven lifting (one side higher) | 1. Chain stretch/wear: The synchronization chain is stretched or worn unevenly. Solution: Check and adjust chain tension. Replace if severely worn. | | Safety locks not engaging | 1. Worn/damaged lock spring: The spring may be weakened or broken. Solution: Replace the spring. 2. Misalignment: The lock mechanism may be misaligned or obstructed by dirt. | | Lift lowers by itself | 1. Failed brake mechanism: The motor's brake or the screw's mechanical brake may be failing. Do not use the lift. Arrange for an immediate professional inspection. |
Any you are currently facing
Position the master column (containing the primary control box).
Contains dimensional drawings showing the base plate footprint (approx. 800x600 mm) and the center of gravity of the lifted load. Use this to plan your garage layout.
Proper installation is critical to prevent structural failure. The GTE 2500 requires a flat, reinforced concrete foundation to anchor the asymmetric columns safely. Foundation Requirements
Press the "Up" button until the pads make contact with the chassis. Verify secure contact. The absolute minimum footprint area for the foundation
Clean the lifting screws and apply approved high-pressure grease. Inspect nuts for wear. Top limit switch stuck or misaligned.
The manual includes a diagnostic chart for common issues, such as:
Check beneath and around the vehicle to ensure no tools, jacks, or personnel are present. Press the "Down" button.
Extend the lifting arms under the manufacturer-recommended pick-up points. or personnel are present.
