V2000-c Rfid Access Control User Manual -

Comprehensive User Guide: V2000-C RFID Access Control System

Always turn off the 12V DC power supply before splicing any wires to prevent short circuits. Lock Wiring:

1,000 to 2,000 users (depending on the specific firmware version) Card Reading Distance: 3–8 cm V2000-c Rfid Access Control User Manual

Enter a unique User ID (1-2500) + # + [4-6 digit PIN] + # . Press * to exit. Deleting Users Enter Programming Mode. Press 2 . By Card: Swipe the card you wish to delete. By ID: Enter the User ID + # . Press * to exit. 5. Advanced Settings Door Relay Time

A: Check the status of the Red (Power) and Green (OK) LEDs. If the Red light is off, check your 12V power supply. If the Red light is on but the Green light does not flash when presenting the card, the card may not be registered in the database. Try re-adding the user. Comprehensive User Guide: V2000-C RFID Access Control System

, often associated with brands like OboHands, is a waterproof, metal-cased keypad designed for single-door access. It allows entry via three methods: RFID proximity card/fob (125KHz), PIN password, or a combination of both. 123456 Operating Voltage: DC 12V Card Type: EM or EM-Compatible 125KHz (Proximity) Capacity: Up to 2,000 Users Installation Guide (Wiring & Mounting)

I can provide a custom wiring diagram step or exact programming sequences for your specific setup. Share public link Deleting Users Enter Programming Mode

Ensure you are using a 125 kHz EM-frequency card. Mifare 13.56 MHz cards are incompatible with the V2000-C standard reader.