Action Step: Disconnect your DVR from the internet router while trying default passwords to prevent account lockout strings caused by automated network requests. 2. The Dynamic QR Code & Mobile App Method
Once access is granted, the system will force a prompt to create a new admin password immediately. Method 2: The Physical Factory Reset Button
This is for advanced users only. By flashing modified firmware, you can bypass the password screen entirely.
Reconnect the power and attempt the default logins listed above. 2. The Master Password Generator Method (Software Bypass)
As a last resort, desolder the 8-pin EEPROM chip (typically 24C02 or 24C64 ) from the motherboard. Use an EEPROM programmer (like CH341A) to read the data. Search for the hex values near the ASCII text admin and replace the password salt with zeros. Rewrite the chip and resolder. traice dvr password reset exclusive
For a visual guide on navigating these menus and identifying the hardware reset button on similar DVR motherboards, watch this tutorial: DVR Password Reset #dvrpassword Technical Th1nker YouTube• Dec 16, 2023 Key Locations for Traice Support
Try the following standard combinations at the login prompt: admin | Password: (Leave blank) Username: admin | Password: admin Username: admin | Password: 123456 Username: admin | Password: 888888 Username: admin | Password: 000000 Basic Power Cycle Disconnect the power cable from the back of the DVR.
Create a strong, unique 8-character password.
: If your unit is labeled "Exclusive" by a specific vendor, contact their technical support with your serial number and date to receive a one-time reset code. support.firesecurityproducts.com.au Action Step: Disconnect your DVR from the internet
Most Traice DVR models (especially the XVR and NVR hybrids) feature a physical reset mechanism on the motherboard. This is the most reliable way to bypass a lost password without needing specialized software. Unplug the DVR from its power source.
⚠️ This works if the DVR has not been updated to newer firmware that blocks third‑party reset tools.
Note down the exact (e.g., 25-05-2026 ).
If the DVR is connected to a network and email was set up: Method 2: The Physical Factory Reset Button This
Traice DVR Password Reset Exclusive: Ultimate Recovery Guide
, plug the power cable back into the unit.
: Use tools like Superadmin.exe or GenSuperPassword.exe on a separate PC. Input the DVR's displayed date into the software to generate a master code.
I can provide the precise unlock sequence or master key for your specific system parameters. Share public link
Hold the button down, plug in the power, and continue holding for 30 seconds until you hear a beep or see the system reboot. 2. CMOS Battery Removal