Designed to integrate seamlessly with standard Mitsubishi sensors and actuators. Where to Find the Mitsubishi LE-30CTA Manual
The controller is designed for efficiency, offering both automatic (closed-loop) and manual operation modes. Essential Information from the LE-30CTA Manual
Before powering up, ensure your input voltage matches the terminal requirements (usually 100-240V AC). Power supply. Terminals 7 & 8: Output to your clutch or brake.
For the controller to work, it needs to know what "zero" weight feels like.
The actual tension continuously oscillates above and below the target setpoint.
Mitsubishi Tension Controller LE-30CTA is a feedback-type automatic tension controller designed to maintain constant material tension in roll-to-roll applications like printing, slitting, and coating. It is often grouped technically with the
Mitsubishi's tension controllers, such as the LE-30 CTA model, are designed to accurately control tension in various industrial applications, including web processing, unwinding, and winding. These controllers are part of Mitsubishi's automation and control solutions, aimed at enhancing productivity and product quality.
Terminate the shield only at the controller side to prevent ground loops. Output Connections
The LE-30CTA connects to Mitsubishi LX-TD tension detectors using a 4-wire or 2-wire shielded cable network.
Always connect this to a dedicated ground. It reduces electrical noise, which can interfere with load cell readings. Tension Detector (Load Cell) Connections
Enter the system parameter menu and select the option.
Used exclusively during winding. It gradually decreases the tension as the roll diameter grows, preventing internal telescoping or crushed cores. 5. Troubleshooting Common Fault Codes and Errors
The Mitsubishi LE-30CTA is a high-performance automatic tension controller designed for unwinding, intermediate, and winding applications. It uses feedback from tension detectors (load cells) to regulate electromagnetic clutches, brakes, or AC servo systems.
To help tailor any further assistance, could you share a few details about your setup?