Vtech Electronic Talking Battleship Command Manual

The computer will report the results at the end of the volley (e.g., "Two hits, three misses") without specifying which coordinates hit. 3. Solo Campaign

Press the (Up, Down, Left, or Right) to indicate which way the ship stretches.

: Attacks a cross-shaped pattern or a wider area instead of a single coordinate point. Troubleshooting and Maintenance

Place your 5 ships (Carrier, Battleship, Cruiser, Submarine, Destroyer) on your lower ocean grid. Vtech Electronic Talking Battleship Command Manual

A standard game of Battleship against a human or the computer.

The game console requires steady DC power to run its internal computer, voice synthesizer, and LED display elements. Close the game console and turn it upside down.

Choose a target coordinate on your upper tracking grid (e.g., F7 ). Input Coordinate: Type F then 7 on your electronic keypad. Fire: Press the Fire / Enter button. Listen for the Result: The computer will report the results at the

This is the primary sign of low batteries. Replace all four at once.

Hit: The computer plays an explosion sound and shouts "Hit!" Place a on your upper tracking grid at F7.

: Press 1 to select one of 100 pre-programmed ship configurations. Enter the letter-number code from the manual for your chosen formation. : Attacks a cross-shaped pattern or a wider

A two-player mode where the computer acts as the referee, tracking hits and misses for both sides.

The console plays an explosion sound effect and says "Hit!" Place a red peg into coordinate F-7 on your upright Target Grid. Your opponent must also place a red peg into the physical ship on their horizontal Ocean Grid.