Xta-7000 Temperature Controller Manual Extra Quality [2024]

Relay contact (250V AC / 3A) or SSR drive (12V DC, 30mA)

Which you are currently trying to figure out?

Indicate output activation (OUT), alarm triggering (ALM1/ALM2), and auto-tuning mode execution (AT). 4. Parameter Programming and Configuration xta-7000 temperature controller manual

Thermocouple: Connect the positive wire to Terminal 9 and the negative wire to Terminal 10.

Do not adjust the machine until the flashing stops. The process takes anywhere from 10 to 45 minutes. 5. Advanced Parameter Codes Relay contact (250V AC / 3A) or SSR

Relay Output Type: Connect your load circuit through the Normally Open (NO) and Common (COM) terminals. (Typically rated at 250V AC, 3A).

Using the manual as a map, he navigated to the parameter code for . check your external fuse

Drop a comment below with your error code or symptom.

Cause: Input sensor open-circuit, broken thermocouple wire, or measured temperature exceeds the upper safety limit.

Check the OUT indicator light. If it’s on but there is no heat, check your external fuse, contactor, or SSR. 6. Safety Warnings