| Pin | Name | Description | | --- | --- | --- | | 1 | VDD | Logic supply (e.g., +15 V) | | 2 | HIN | High‑side logic input (PWM) | | 3 | SD | Shutdown – usually tied to GND | | 4 | LIN | Low‑side logic input (PWM) | | 5 | VSS | Logic ground | | 6 | VB | High‑side floating supply (bootstrapped voltage) | | 7 | HO | High‑side gate output (to top MOSFET) | | 8 | VS | High‑side floating return (source of top MOSFET) | | 9 | VC | Low‑side supply – connect to VDD | | 10 | LO | Low‑side gate output (to bottom MOSFET) | | 11 | COM | Low‑side return (power ground) |
If you found this guide helpful, share it with your engineering colleagues. Have a specific error? Leave a comment below with your Proteus version and schematic, and we will help you debug it.
: Many such files contain malware. Always scan downloads and prefer trusted communities. ir2110 library for proteus 8 link
The IR2110 is a high-voltage, high-speed power MOSFET and IGBT driver. It is one of the most essential components in power electronics simulation, particularly for designing Half-Bridge, Full-Bridge, and Buck-Boost converters.
What specific (if any) are you getting in Proteus? Which version of Proteus 8 are you running? | Pin | Name | Description | |
In the world of power electronics simulation, designing high-side and low-side driver circuits is a common challenge. The is one of the most popular high-speed MOSFET and IGBT drivers, making it essential for projects involving H-bridges, buck/boost converters, and inverter circuits.
If the library is correct, the high-side gate drive voltage (HO – VS) should swing from 0V to approximately 12V (VCC minus diode drop). If floats or HO stays low, your library is faulty. : Many such files contain malware
C:\Program Files (x86)\Labcenter Electronics\Proteus 8 Professional\LIBRARY
This procedure applies to any manual library installation in Proteus 8, including the IR2110.
Press the key on your keyboard (or click the "P" button) to open the Pick Devices window. In the Keywords text box, type: IR2110
The IR2110 is a High and Low Side Driver. It is not a simple logic gate; simulating it requires understanding its power requirements. If you place the component and run the simulation without the correct setup, it will fail or output nothing.