Stenhoj Ds2 Manual Jun 2026

Check workshop breakers. Test for 3-phase voltage at the main switch. Reset thermal relays.

Typically 3,000 kg (3 tonnes) to 3,500 kg (3.5 tonnes).

Leave a comment below with your DS2 model variant, and we will help you locate the correct manual section. Always follow local safety regulations when installing or repairing industrial remote control systems. stenhoj ds2 manual

Ensure no tools or people are under the lift. Press Lower: Hold the down button on the control panel.

Swing the lift arms under the vehicle lifting points. Check workshop breakers

| Symptom | Likely Cause | Suggested Solution | | :--- | :--- | :--- | | | The lift nut on the slave column is worn or misaligned, causing it to jam on the spindle. | Inspect the lift nut for wear. Ensure the clearance between the primary and secondary nuts is correctly adjusted. | | Lift does not operate after servicing | A safety interlock mechanism, such as a limit switch or an engagement pawl, may be incorrectly positioned. | Check all safety interlocks. On some models, a pawl that engages at the lowest point must be manually retracted before the lift will move upward. | | Intermittent operation / some relays not working | Electrical issues are common in older M&E models. Corroded contacts, failed relays, or faulty limit switches are likely culprits. | Test relays and sensors individually. Clean all electrical contacts in the control cabinet. Isolate and test the motors by connecting them directly to power to rule out major component failure. | | Unusual noises or jerky movement | Worn chain guides, a loose SPZ belt, or dry bearings can cause mechanical noise. | Inspect and replace chain guides and belts as needed. Lubricate all bearings and moving joints per the service manual schedule. | | Lift does not go up or down | The safety lock pawls have engaged, preventing movement. This often happens at the lift's lowest position. | Safely access the pawls at the base of each column and manually retract them using a pry bar or similar tool before attempting to operate the lift again. |

What is the on your lift's ID plate?

For DS2 owners, this heritage is significant. It means your lift was designed and built with a long-term focus on quality and serviceability. Despite the corporate change, the service network and access to original parts and documentation remain a key advantage, a point that will be repeatedly emphasized in the section on obtaining the manual.

Based on numerous first-hand accounts, the most reliable method is to contact . Multiple users on automotive forums have reported that the company is surprisingly helpful, even for lifts that are several decades old. Typically 3,000 kg (3 tonnes) to 3,500 kg (3