Life Probo Pr70 Instructions For Installation Use And Maintenance Manual 10 Pages Upd Jun 2026

Identify the remote control by pressing the button on the control unit until the red LED flashes, then hold the remote key until the green LED confirms identification. 3. Programming and Use probo pr70 pr70-dl

Perform the obstruction test with a block of wood on the floor. Door Springs & Tracks

A grounded 230V power outlet should be available near the motor head. 2. Mechanical Installation Identify the remote control by pressing the button

Pull the cord firmly downward and backward toward the motor head.

: Obstacle detection sensitivity can be adjusted by holding the red button for five seconds and using the plus/minus keys to select a level. Electrical Connection Door Springs & Tracks A grounded 230V power

All electrical work must be performed with the main breaker shut off.

The door must stop instantly and reverse to the fully open position. 9. Routine Maintenance Schedule : Obstacle detection sensitivity can be adjusted by

Lubricate the garage door rollers, hinges, and springs with a silicone-based spray. Do not grease the operator rail.

A red LED indicator light will illuminate or flash on the board.

Secure the operator to the runner using the provided omega-shaped support brackets and screws. Ceiling Mounting Position the runner parallel to the ceiling.